Crivit SP - 33 User Manual download pdf (Page 4)

Bicycle helmet SP - 33

3. Adjusting the strap divider

• Open the strap divider (Fig. D)

• The strap divider must be positioned in such a way, that the straps are taut but comfor-

table. The strap divider must be below the ear, and the straps must not cover the ears.

• Close the strap divider (Fig. E)

An open strap divider can lead to slipping of the helmet in the event

of an accident and thus to a loss of protection!!!

4. Adjusting the chin strap

• The chin strap (Fig. G.3) has been adjusted correctly if you feel slight pressure when

you open your mouth.

• If the chin strap (Fig. G.3) is too loose it must be pulled tight using the winding (Fig.

G.2) on the fastener (Fig. G.1).

• If the chin strap (Fig. G.3) is too tight it must be loosened also using the winding (Fig.

G.2) on the fastener (Fig. G.1).

Please note that you must always make sure that the fastener is

closed before you ride !!! (Fig. F)

Please be aware that the helmet can only protect if it ts properly.

Please try out different sizes and choose the one in which the helmet

ts comfortably and sits rmly upon your head.

5. Visor

• Carefully pull out the pins on the visor from the pin holes on the helmet shell to remo-

ve the visor (Fig. H).

Attention: The pin holes on the helmet can expand through excessive

use. In this case, the visor may no longer be used.

6. Cleaning and care

• All chemicals, paints and stickers can seriously impair the protective effect of the

helmet.

• Only clean your helmet with lukewarm water, mild soap and a soft cloth.

• After every use, leave your helmet exposed to the air in order for it to dry.

7. Disposal

Please contact your local waste disposal company for the disposal of the helmet.

130124_4+5-14_ LB07_GA.indd 6 08.03.2013 11:31:01

1 2 3 4 5 6 7 8 9 ... 29 30

No comments

Crivit SP - 33 User Manual Page 4