Crivit FT-1400 User Manual download pdf (Page 7)

Rebounder assembly

The included rebounder can be

secured to the goal frame using

the pre-installed clip fasteners.

Then anchor the rebounder to

the two front bottom goal corners

using the pre-installed hooks.

Note: If the elastic of the click-system has released from one of the plastic fasteners it can

be refastened as illustrated. Pull the elastic band through the grommet of the loose clip

connector, then feed the other end of the elastic band with the clip still attached through

the resulting loop and pull the band tight.

Securing the goal

After assembling the goal the

rebounder must be secured from

tipping.

Use the included earth-pins for

this purpose. Be sure the earth-pins

are completely pushed into

ground.

Secure the included 6 ground spikes

to the rear bar of the goal

Note 1:

Please consider the composition of the ground. The earth-pins could easily release from

loose ground, therefore posing a hazard to the players.

Note 2:

Always remove the rebounder when the goal is not in use to prevent damage caused by

wind.

ﬁg. 4

ﬁg. 3

1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

No comments

Crivit FT-1400 User Manual Page 7