9 10
Cheek Pads
You will receive two different pairs of cheek pads for
individual size adjustment.
The thinner cheek-pads are already pre-mounted as
standard. The thicker cheek pad is enclosed with the
helmet separately.
If the helmet is too loose and therefore is not sitting
firmly on your head, you can replace the thin cheek
pad with the thicker ones.
The cheek pads are affixed via three press-studs
respectively in the helmet. You can easily remove the
pads ( see Fig. F ). The thicker cheek pads can now
also be affixed in the helmet with three press-studs.
You need to be able to hear that each press-stud
locks-in.
Winter Collar
To reduce the wind intake at the bottom side of the
helmet during extremely cold temperatures, the pre-
mounted helmet-collar can be replaced by the broad
winter collar which is included.
Removal of Helmet Collar
The three-piece collar is affixed to the helmet with a
strong Velcro-strip. Remove the three collar parts by
pulling them off ( see Fig. G ).
Inserting the Winter Collar
First attach the plastic clip in the centre at the back
part of the helmet in the groove between the outer
shell and the padding.
Once the plastic clip is completed locked-in, press the
complete winter collar again firmly onto the padding
of the helmet.
Visor Replacement
If the pre-mounted visor is damaged or severely
scratched, you can exchange it with the replacement
visor.
Removal of the Visor
- Slide the visor to the uppermost position ( fully
opened ).
- Press down on the visor securing button on both
sides of the helmet and slide the visor down out of
the visor holding device ( see Fig. H ).
Inserting the Visor
- Place the visor onto the visor fixture whilst making
certain that you maintain the correct positioning
( fully opened ).
- Slide the visor up on both sides of the helmet onto
the visor holding device until it is completely fixed.
Maintenance and Care
Regular maintenance and care contributes to safety and maintaining the helmet.
Cleaning of the Helmet
- Never use solvents, petrol or other detergents when cleaning the shell and interior of your
helmet.
- Only use water and pH balanced soap.
Visor care and cleaning
- After using the helmet, with a soft cloth, lightly wipe off any grime (e.g. dead insects, dirt,
sand, dust etc.) from the visor and then fully wipe it clean using a dry soft cloth.
- When the visor gets wet (e.g. rainwater) it should always be wiped with a soft cloth.
- When cleaning the visor, never use any petroleum-based solvents or detergents containing
abrasives.
Cleaning of the Cheek Pads, Acoustic Pads and Inside Pads
- Hand wash below 30° C.
- Allow to dry at room temperature.
- Avoid sources of heat.
- When not in use, store in a dry, well ventilated place.
(6 pages)
(10 pages)
(32 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals